Power Design Services (PDS) is now: Visit GreenCircuits.com

When to Outsource Reworking Integrated Circuits on a PCB

The days when beginner-level soldering was suitable for reworking integrated circuits (ICs) on a PCB are long gone. Reworking modern PCBs often requires expert attention and surgical precision.

Additionally, ball grid arrays, quad flat no-leads packages, and other common technologies typically require specialized equipment that manufacturers simply don’t have at hand.

So when is it appropriate to outsource reworking integrated circuits, and when is the job simple enough to be done in-house?

Before IC Reworking – Identify Costs and Predict Likely Outcomes

One of the first steps to determining how to approach your IC reworking project is identifying costs and likely outcomes. Damaged PCBs can span the range from exhibiting almost unnoticeable malfunctions to near-complete physical destruction. Just like patients in a hospital, proper diagnosis is key to predicting how the recovery process will go – there is a world of difference between treating a headache and a heart attack.

The key to making this decision is determining what went wrong with the circuit in question. Environmental issues such as unexpected condensation build-up can sometimes be resolved simply. However, if the damage is extensive, then outsourced IC repair may be your only option.

Examine your needs and determine how closely you need the finished, repaired PCB to duplicate the physical characteristics of the original. How much variance can you tolerate? Most electrical issues – resistance, inductance, capacitance, cross talk, and frequency – require specialized expertise and equipment to address.

When considering the cost of reworking a PCB, you must also take into consideration the skill level of the engineer performing the work. PCB repair personnel cannot be part-timers who rotate repair duties alongside traditional PCB assembly responsibilities.

Manufacturers who try this almost universally fail because PCB repair skills are far more involved and more specific than assembly skills. There are far more steps involved in any repair operation than in most typical assembly procedures.

Beyond relatively simple conductor repair with epoxy seals or surface wires, it is likely that any advanced reworking will ultimately fail unless addressed by a demonstrated career expert in PCB repair. Otherwise, you risk damaging the board or disturbing surrounding components, and this risk is simply too much for most manufacturers to bear.

Consider the Type of IC Rework Required

Another critical issue for manufacturers to consider is the type of rework required. Most in-house PCB manufacturing engineers don’t have the experience or the equipment to rework ball grid arrays or quad flat no leads packages with any degree of consistency.

Handling these components requires specialized training on purpose-built equipment that the vast majority of manufacturers don’t have because they don’t typically need it.

Additionally, PCB reworks such as adding jumper wires, cutting traces, or replacing components are best left to dedicated repair technicians. With the right talent on the job, you can ensure top-quality results and a reasonable guarantee of success. You can even use outside talent to make components with the incorrect footprint fit on a board –  something that few in-house engineers would be comfortable attempting.

Logo1
Logo2
Logo3
Logo4
Logo5
Logo6
Logo7
Logo8

Contact us

Green Circuits
1130 Ringwood Ct.
San Jose, CA 95112
408-437-1931
info@GreenCircuits.com

Power Design Services is now